OCC Lance Armstrong Bike / Leno Bike
OCC Lance Armstrong Bike / Leno Bike | |
Manufacturer | |
---|---|
Weight | |
Manuals | Service Manual |
PhotosEdit
OverviewEdit
OCC
OCC Leno Bike
Paul Sr. took hold of the ropes and went to work
on a motor to kick the project off. He contacted Accurate Engineering to get a
special 103ci V-twin built. To lend a nod to the Brough era, Accurate used a
Knuckle-style 3.8125-inch top end mated to an Evo bottom end that holds the
4.5-inch stroke wheels and rods. A Crane ignition and CV carb supply spark and
fuel to the unusual motor.
At the same time the motor was being assembled,
Paul Jr. was getting the roller together. He used an OCC rigid frame built with
35 degrees of rake and 5 inches of downtube stretch as the build platform.
Jeri's Springer built a tandem shock unit that replicates as much of the
original Brough design as possible, while still working with the design OCC had
in mind. To roll the bike around, Paul Jr. had American Wire Wheel build a set
of black and white powdercoated wheels.
The 21-inch front wears a Metzeler tire and
Tedd's V-twin caliper and rotor. Out back, an 18x8.5-incher is covered with a
240mm Metzeler and is slowed by a drive-side rear kit from Tedd's.
When the Knuckle showed up, it was immediately
placed in the frame with a five-speed RevTech transmission (equipped with a
kicker) mounted behind it. To get power transferred between the two, a 3-inch
beltdrive from BDL, with a cover plate that accommodates the ignition switch,
was put into service. That allowed the OCC 2-into-2 exhaust system to be built
and fit to the powertrain design.
When it came time for sheetmetal, Paul Jr. jumped
in fast. First, a low-profile, one-piece gas tank was formed. Once completed, it
was time to create a front fender that mounted with the same style struts as an
original Brough. He then built a massive rear fender to cover the 240 and used a
similar strut mounting system. Adding to the rear fender dimension is a curved
rack that also nods back to the original bike's design. Once all the metal was
fit properly, Justin Barres at JB Graphix took over. Each piece was smoothed out
to make way for the combination of black and silver paint that gives the Leno
bike its old-school look.
A few final details were added during reassembly,
like a vintage-style plate mounted on the front fender wearing the date of Jay's
first appearance on the Tonight Show, and a rear plate calling attention to
same. OCC bars with Ness hand controls were mounted above a Tedd's headlamp with
Accutronix forwards down below. OCC turned to Tedd's for the vintage taillight
and spring seat, and called the bike done.
Jay was presented the bike on the Tonight Show,
and in turn, he appeared on American Chopper to take his first ride. As Jay
pulled back in from that ride, he smiled that oh-so-recognizable smile and said,
"Now that is my kind of chopper!"
Source and full article