Editing BMW K75
Jump to navigation
Jump to search
Warning: You are not logged in. Your IP address will be publicly visible if you make any edits. If you log in or create an account, your edits will be attributed to your username, along with other benefits.
The edit can be undone. Please check the comparison below to verify that this is what you want to do, and then publish the changes below to finish undoing the edit.
| Latest revision | Your text | ||
| Line 46: | Line 46: | ||
|oil_filter= {{oilfilter|K&N KN-163}}<ref name="kl_2019">{{cite book|title=2019 K&L Supply Co Catalog|publisher=[https://www.klsupply.com/ K&L Supply Co]|date=2019}}</ref> | |oil_filter= {{oilfilter|K&N KN-163}}<ref name="kl_2019">{{cite book|title=2019 K&L Supply Co Catalog|publisher=[https://www.klsupply.com/ K&L Supply Co]|date=2019}}</ref> | ||
}} | }} | ||
The '''[[BMW]] K75''' was | |||
The '''[[BMW]] K75''' was a [[inline three cylinder]], [[four-stroke]] Naked [[motorcycle]] produced by [[BMW]] between 1985 and 1996. It could reach a top speed of 121 mph (194 km/h). Max [[torque]] was 49.2 ft/lbs (66.7 Nm) @ 6750 RPM. Claimed [[horsepower]] was 73.35 HP (54.7 KW) @ 8500 RPM. | |||
An all-new design that was supposed to replace [[BMW]]'s traditional flat-twins, the [[BMW K100|BMW K100]] arrived for 1984 restating the virtues of solidity, comfort and exemplary build quality long associated with the marque. An 8-valve twin-cam unit displacing 998cc, the brick-like, four-cylinder motor was laid on its side, lowering the center of gravity, and mounted fore-and-aft to facilitate the retention of BMW's characteristic shaft drive. Bosch electronic fuel injection was employed and the long-stroke four developed its maximum output of 90bhp at a relatively low 8,000rpm. In 1985 the K100 spawned a 740cc three-cylinder K75 variant that featured a 120-degree crankshaft and a higher compression ratio. Weighing less than the K100 and with 75bhp on tap, the K75 was a lively performer and deservedly popular, but did not receive the development that went into the four-cylinder models, which would later benefit from four-valves-per-cylinder heads. The usual range of BMW model variants was produced up to the end of three-cylinder K-Series production in 1995. | An all-new design that was supposed to replace [[BMW]]'s traditional flat-twins, the [[BMW K100|BMW K100]] arrived for 1984 restating the virtues of solidity, comfort and exemplary build quality long associated with the marque. An 8-valve twin-cam unit displacing 998cc, the brick-like, four-cylinder motor was laid on its side, lowering the center of gravity, and mounted fore-and-aft to facilitate the retention of BMW's characteristic shaft drive. Bosch electronic fuel injection was employed and the long-stroke four developed its maximum output of 90bhp at a relatively low 8,000rpm. In 1985 the K100 spawned a 740cc three-cylinder K75 variant that featured a 120-degree crankshaft and a higher compression ratio. Weighing less than the K100 and with 75bhp on tap, the K75 was a lively performer and deservedly popular, but did not receive the development that went into the four-cylinder models, which would later benefit from four-valves-per-cylinder heads. The usual range of BMW model variants was produced up to the end of three-cylinder K-Series production in 1995. | ||