How to port your Engine

From CycleChaos
Jump to navigation Jump to search

I'm not responsible in any way if you hurt yourself or ruin/damage your motorcycle. You've been warned!

Here's how to port (increase the airflow) of your cylinder head. You can do it yourself this way or spend $250+ for similar results. All you need is about $20 dollars for tools and the skill to take off your cylinder head or cylinder if you have a 2-stroke.

Part I[edit | edit source]

Step One:[edit | edit source]

Buy a small file set (swiss cut preferably) "needle" files about 5 or 6 inches long. You should be able to get a set of 6 for about $7 dollars at your local hardware store. The cheap ones will work just fine.

Step Two:[edit | edit source]

Take off your cylinder head and clean the intake and exhaust ports with solvent (ports, not valves, although you can clean those if you would like).

Step Three:[edit | edit source]

Look inside the intake port as there will likely be some small deformities (they look like lumps, but not very high) on the sides on the port. They will probably run in a line, the textured surface of the intake port is normal. It allows the fuel and air to mix because of the slight turbulence around the walls of the port.

Step Four:[edit | edit source]

With adequate lighting, choose a file that will fit the area with the deformity you would like to smooth out. You just need to bring the casting deformity down to be level with the rest of the sides of the port. Slowly file the deformities away, until they are gone. DO NOT POLISH THE INTAKE PORT.

PART II[edit | edit source]

Step One:[edit | edit source]

Exhaust porting. Clean out carbon build up with solvent and a fine scotch brite pad or a green one if you want to save time.

Step Two:[edit | edit source]

Choose a file, and remove the casting flaws (deformities) in the exhaust port.

Step Three:[edit | edit source]

When the flaws in the EXHAUST port have been removed, you may polish the port with sand paper. Make it as smooth as you would like. You can also match the exhaust port to the header and gain a few extra horsepower just from that.

Good luck and remember that you will be doing this at your own risk.