|Engine||Two stroke, single cylinder, air cooled|
|Bore / Stroke||71.1mm x 71.1mm|
|Horse Power||24.0 HP (17.9 KW) @ 7000RPM|
|Torque||17.7 ft/lbs (24.0 Nm) @ 6000RPM|
|Transmission||Gear box: 6-Speed |
Final Drive: Chain
|Suspension||Front: Telescopic forks |
Rear: Dual shocks
|Brakes||Front: Drum |
|Wheelbase||54.69 inches (1389 mm)|
|Dimensions||L 82.72 inches (2101 mm)|
W 35.0 inches (889 mm)
|Seat height||32.01 inches (813 mm)|
|Weight||(dry), 122.0 kg (wet)|
|Tech Specs · Brochures · Reviews · Ads · Videos|
The Yamaha DT-3 250 was a Two stroke, single cylinder, air cooled Enduro motorcycle produced by Yamaha in 1975. Max torque was 17.7 ft/lbs (24.0 Nm) @ 6000 RPM. Claimed horsepower was 24.0 HP (17.9 KW) @ 7000 RPM.
The bike has a 6-Speed transmission. Power was moderated via the Wet, multiplate.
It came with a 3.25-19 front tire and a 4.00-18 rear tire. Stopping was achieved via Drum in the front and a Drum in the rear. The front suspension was a Telescopic forks while the rear was equipped with a Dual shocks. The wheelbase was 54.69 inches (1389 mm) long.
- Starting Engine#: DT1F-135101
1975 Yamaha DT-3 250
The DT's engine was your basic 250cc air-cooled two-stroke single that was dirt reliable plus dirt cheap to operate and maintain. Fed by a 26mm Mikuni carburetor and with 6.8:1 compression, the 246cc (15 seven ports on its "Torque Induction" two-stroke engines). Along with the standard intake, exhaust and transfer ports, Yamaha used an additional two transfer ports along with holes in the piston skirt. These ho would normally be covered by the skirt. This small detail resulted in a slight increase in power, and better throttle response than Yamaha's pre 1972 engines.